Joined: 11 Nov 2006
|Posted: Sat Nov 11, 2006 10:57 pm Post subject: st205 ecu system on a st165 loom
|Hi Guys, i have started again with getting the st205 system running on my st165/st185.
basically the car will start run for a couple of seconds and then dies.
if i touch the throttle it does even quicker!?
when it runs it sounds smooth and no miss fire.
There are no error codes at all.
I have disconnected the ISC and this makes no difference, on a 165 it should idle at 1k rpm.
FC wire has been cut from the COR and the wire has been connected directly to the Ecu COR ---> Ecu
tried running the car with the st165 Ignitor, no difference.
any suggestions, at a dead end
ST-165 88 UK (BETSY) Blows like divine Brown
301BHP @ 13psi
1/4 mile 12.9
Refit complete (ADL!)
(Officialy run in)